Single Tool Holster in black and orange to tether tool at height
Single Tool Holster in black and orange to tether tool at height

Single Tool Holster

SKU: TH-ST
WLL: 5 kg

£0.00

The Single Tool Holster is a simple option for carrying an individual long handled tool at height. It is deep enough to support the tools load from the bottom while leaving enough exposed at the top for quick pick-up.

SKU Type Quantity
TH-ST-LF Loop fastening
TH-ST-VF Velcro fastening
SKU: TH-ST Categories: ,

The Single Tool Holster is a simple option for carrying an individual long handled tool at height. It is deep enough to support the tools load from the bottom while leaving enough exposed at the top for quick pick-up. Where an ordinary single tool holster might split at the bottom after heavy use, this seamless design makes it impossible for the holster to fail from localised point-loading.

• Seamless bottom
• Convenient size
• Perfect for long handled tool
• 1 x tethering point

Volume: 0.6L / Height: 34cm / Diameter: Ø 6cm / Weight: 125g

WLL 5kg

All-in-one safety.

All Leading Edge tool tethering products are tested and certified in accordance with EN364-1992 test methodology. It conforms to the provision and scope of our testing and quality procedures as per the PPE Regulations (EU)2016/045, where applicable and relevant within the fit for purpose design parameters.

Safety Factors.

All certified Leading Edge products boast a whopping 47x safety factor. We purposefully over engineer our products to have greater resilience than a real world scenario would require — this gives them superior in-service lifespan and fully 3guarantees your safety in daily use.

Testing Methods.

All tool safety equipment classified as UKCA approved must surpass two rigorous testing methods.

Static Test.

We attach the product to an anchor point and apply pressure by hanging a weight from it. A product only passes if it is able to withstand the load for a minimum of three minutes without signs of damage or weakening.

Dynamic Drop Test.

We attach the product to an anchor point and apply pressure by hanging a weight from it. A product only passes if it is able to withstand the load for a minimum of three minutes without signs of damage or weakening.

Every item that leaves our factory comes with full documentation containing technical specifications, serial numbers, testing methods, working load limits and inspection results proving it has passed all necessary requirements for work at height.