Triple-Lock Tether for waisted and captive tool handles, in black grey and orange.
Triple-Lock Tether for waisted and captive tool handles, in black grey and orange.
Triple-Lock Tether on power drill

Triple-Lock Tether

SKU: TT-TL
WLL: 5 kg

£0.00

The Triple-Lock Tether is a versatile tethering device for waisted and captive tool handles.

SKU Size Quantity
TT-TL-0.05 Max 50mm
TT-TL-0.08 Max 80mm
SKU: TT-TL Categories: ,

The Triple-Lock Tether is a versatile tethering device for waisted and captive tool handles. Its unique velcro fastening system features 3 straps that overlap in opposing directions to massively increase their tensile strength. This means it is not only incredibly secure but also easy to attach, reposition and remove. At only 14mm in height, the anchor occupies minimal space, especially important when your tool handle has limited surface area. It may also be used as anchorage for scaffolding and handrails etc.

• Triple-Lock for extra safety
• Easy positioning
• Use as both a tether and an anchor point

WLL 5kg

All-in-one safety.

All Leading Edge tool tethering products are tested and certified in accordance with EN364-1992 test methodology. It conforms to the provision and scope of our testing and quality procedures as per the PPE Regulations (EU)2016/045, where applicable and relevant within the fit for purpose design parameters.

Safety Factors.

All certified Leading Edge products boast a whopping 47x safety factor. We purposefully over engineer our products to have greater resilience than a real world scenario would require — this gives them superior in-service lifespan and fully 3guarantees your safety in daily use.

Testing Methods.

All tool safety equipment classified as UKCA approved must surpass two rigorous testing methods.

Static Test.

We attach the product to an anchor point and apply pressure by hanging a weight from it. A product only passes if it is able to withstand the load for a minimum of three minutes without signs of damage or weakening.

Dynamic Drop Test.

We attach the product to an anchor point and apply pressure by hanging a weight from it. A product only passes if it is able to withstand the load for a minimum of three minutes without signs of damage or weakening.

Every item that leaves our factory comes with full documentation containing technical specifications, serial numbers, testing methods, working load limits and inspection results proving it has passed all necessary requirements for work at height.